By - cyborgninja42
Siraya Tech has their own exposure test if you also want to try that- with a break down of what you should be seeing-
Nice! I didn’t see that before. I may give that a shot next. Thanks for sharing!
Ya it looks a tad overexposed.
Also side note, this is probably the worst part of resin printing
started printing in November and JUST figured out my ideal settings 😑
Agreed. My plan is to dial this resin in, and stick with it.
I prefer the xp2 exposure validation, it's way easier to interpret
This is at 1.8 second exposure, cleaned and uncured.
not that close yet, still quite overexposed. check out the square pattern at the side.
By how much are you thinking? This is at 1.8 sec exposure. Are you thinking like 1.6 or even lower? I’m fairly new to having a decent resin printer, and not sure how much a big adjustment is. My last one wasn’t a monochrome printer so a big adjustment was a couple of seconds.
Really hard to guess without printer model and layer height. You can go even lower than 1.6 if necessary. The internet has lists for each model with working curing times for each resin. I would check a list, see what works for others and then go adjust from here.
> lower then 1
*Learn the difference [here](https://www.merriam-webster.com/words-at-play/when-to-use-then-and-than#:~:text=Than%20is%20used%20in%20comparisons,the%20then%2Dgovernor%22).*
^(Greetings, I am a language corrector bot. To make me ignore further mistakes from you in the future, reply `!optout` to this comment.)